Sun strip and decal installation guide

Sun Strip and Decal Installation Guide Using Slip Solution

Tools Needed:

• Sun strip/decal of your choice
• Slip solution: Mix water with a few drops of baby shampoo or mild soap
• Squeegee or credit card wrapped in a cloth
• Spray bottle (filled with slip solution)
• Microfiber towel
• Utility knife or razor blade (for trimming)
• Masking tape (optional)

Step-by-Step Guide:

1. Clean the Surface:

   • Thoroughly clean the windshield or surface where the sun strip or decal will be applied. Use a window cleaner or alcohol-based solution to remove dirt, oils, and any residue.
   • Dry the surface with a microfiber towel.

2. Measure and Position:

   • Use masking tape to mark the edges or centerline for accurate positioning of the sun strip/decal. This helps you align it properly during installation.

3. Prepare Slip Solution:

   • Mix a few drops of baby shampoo (or mild soap) into a spray bottle of water. Shake well.

4. Spray Slip Solution:

   • Generously spray the slip solution on the area where the decal/sun strip will be placed. This allows you to reposition the decal easily before it adheres fully.

5. Peel and Apply:

   • Peel off the backing of the decal/sun strip.
   • With the adhesive side exposed, carefully place it on the wet surface. Adjust the position if needed.

6. Squeegee the Surface:

   • Use a squeegee (or credit card wrapped in cloth) to remove excess water and air bubbles. Start from the center and push outward. Be gentle to avoid damaging the decal.
   • Frequently spray the top surface with slip solution to prevent scratching.

7. Trim Excess (if needed):

   • Use a sharp utility knife or razor blade to carefully trim any excess material along the edges. Use the windshield edges as a guide.

8. Final Squeegee:

   • Once in place, firmly squeegee the sun strip/decal again to remove any remaining water and air bubbles.

9. Dry and Set:

   • Let it dry for 24 hours. Avoid washing the car or using windshield wipers during this period to ensure the decal sets properly.

Tips:

• Use a heat gun or hair dryer to gently warm the decal if you encounter any stubborn bubbles or edges that don't stick well.
• Take your time during the trimming process to avoid uneven cuts.

That's it! You should now have a perfectly installed sun strip or decal using slip solution.